Altera Interlaken MegaCore Function - Manual (Page 87)

June 2012 Altera Corporation Interlaken MegaCore Function
User Guide
Additional Information
This chapter provides additional information about the document and Altera.
Document Revision History
The following table shows the revision history for this user guide.
How to Contact Altera
To locate the most up-to-date information about Altera products, refer to the
following table.
Date Version Changes Made
May 2012 12.0
■ Maintenance release: updated Appendix D, Porting an Interlaken Design from the
Previous Version of the Software to describe porting from the 11.1 release to the 12.0
release.
November 2011 11.1
■ Added parameterizable or dynamically configurable BurstMax.
■ Added parameterizable or dynamically configurable BurstShort.
■ Added parameterizable exposed calendar pages and number of pages.
■ Added global reset signal.
■ Updated description of tx_chX_datain_ready signal in “Arbiter” on page 4–12 and in
Table 5–8 on page 5–7 .
■ Updated Appendix B, Excluding Transceivers for Faster Simulation to clarify global reset
signal not relevant when transceivers are excluded.
■ Moved block-specific reset signal descriptions from Chapter 5, Signals to Appendix B,
Excluding Transceivers for Faster Simulation .
■ Moved reset sequence description from Appendix A, Initializing the Interlaken MegaCore
Function to Appendix B, Excluding Transceivers for Faster Simulation .
■ Added Appendix D, Porting an Interlaken Design from the Previous Version of the
Software .
May 2011 11.0
■ Added information about lane ordering.
■ Added information about in-band calendar bits.
■ Removed Appendix D, Connecting to User-Defined Arbitration and Regrouping.
December 2010 10.1 Initial release.
Contact (1) Contact Method Address
Technical support Website www.altera.com/support
Technical training
Website www.altera.com/training
Email [email protected]
Product literature Website www.altera.com/literature
Nontechnical support (general) Email [email protected]