Tx application interface signals, Tx application interface signals –6, Tx application interface – Altera Interlaken MegaCore Function User Manual
Page 58
5–6
Chapter 5: Signals
Application Interface Signals
Interlaken MegaCore Function
June 2012
Altera Corporation
User Guide
TX Application Interface Signals
The TX application interface provides two channels through which the application
sends data to the Interlaken link.
describe the TX application interface signals. For more
information about these signals, refer to
rx_chX_dataout_empty[T:0]
Output
Indicates the number of invalid bytes on the rx_chX_dataout_data
bus in the current rx_mac_c_clk cycle, starting from the least
significant byte. The value 1 indicates that bits [7:0] are invalid; the value
2 indicates bits [15:0] are invalid, and so on. Width is 4 bits for
variations with a 128-bit wide channel (20G/4L license), 5 bits for
variations with a 256-bit wide channel (40G/8L license), and 6 bits for
variations with a 512-bit wide channel (either of the 100G licenses). For
details, refer to
. (T = width – 1).
rx_status_calendar[P:0]
Output
RX calendar bits from the recent incoming Interlaken link control
word(s). Each 16-bit calendar page is transferred from the upstream
Interlaken partner in bits [55:40] of a single control word. The width of
the rx_status_calendar signal is 16 × the number of calendar pages
you specified in the Interlaken parameter editor. (width is 16, 128, or 256
bits; P = width – 1).
This signal is present only if you expose the calendar pages in the
Interlaken parameter editor. Refer to
“In-Band Flow Control Parameters”
“Calendar and Status Block” on page 4–20
Note to
(1) The Interlaken MegaCore function supports two channels on the application interface. The string “chX” in a signal name indicates two distinct
signal names, one with “ch0” and one with “ch1”, corresponding to the two channels, channel 0 and channel 1.
Table 5–6. RX Application Data Interface Signals
(1)
(Part 2 of 2)
Signal
Direction
Description
Table 5–7. TX Application Interface Clock Signal
Signal
Direction
Description
tx_mac_c_clk
Input
Clocks the Interlaken MegaCore function MAC TX block and therefore, also, the TX
application interface.
For all MegaCore function variations except the 8-lane, 3.125-Gbps variations, Altera
recommends that you drive this signal with the tx_coreclkout signal (in variations with
transceivers), or that you drive this signal with the same clock that drives the
tx_lane_c_clk
signal (in variations without transceivers).
For the 8-lane, 3.125-Gbps variations, the tx_mac_c_clk clock should be driven by a
faster clock than the TX PCS clock. For these variations, Altera recommends that
tx_mac_c_clk
be driven by the same clock that drives the rx_mac_c_clk. For
recommended frequencies, refer to