Pilz PNOZ mmc1p ETH - Manual (Page 17)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
3-7
3.4 Assignment of data areas
3 Modbus/TCP - Data areas
3.4.4 LEDs
LEDs 3- ModbusTCP_Datenbereiche-LEDs-PNOZmulti
The table below describes the Modbus/TCP data areas that contain the
LED status.
Relevant areas for the data are defined in the Modbus/TCP data areas
Discrete Inputs (1x) and Input Register (3x). Read access is available to
these data areas.
Bit 0 = 1: LED OFAULT illuminates or flashes
Bit 1 = 1: LED IFAULT illuminates or flashes
Bit 2 = 1: LED FAULT illuminates or flashes
Bit 3 = 1: LED DIAG illuminates or flashes
Bit 4 = 1: LED RUN illuminates
Bit 5: Reserved
Bit 6: Reserved
Bit 7: Reserved
3.4.5 Configuration
Configuration 3- ModbusTCP_Datenbereiche-Konfiguration-PNOZmulti
The table below describes the Modbus/TCP data areas that contain the
device data from the base unit and the project data. The data was de-
fined in the PNOZmulti Configurator.
Relevant areas for the data are defined in the Modbus/TCP data areas
Discrete Inputs (1x) and Input Register (3x). Read access is available to
these data areas.
Register
(3x) Discrete Input
(1x) Content High Byte Low Byte
520 8335...8320 8 Bit LED status;
8 Bit reserved Reserved PNOZmulti LEDs
521…783 Reserved
Register
(3x) Discrete Input
(1x) Content High Byte Low Byte
784 12559... 12544 Product number HH Byte HL Byte
785 12575... 12560 Product number LH Byte LL Byte
786 12591... 12576 Device version HH Byte HL Byte
787 12607... 12592 Device version LH Byte LL Byte
788 12623... 12608 Serial number HH Byte HL Byte
789 12639... 12624 Serial number LH Byte LL Byte