Pitney Bowes DI425 FastPac Inserting Systems - Manual (Page 57)

OMR • 3
3-19 SV61656 Rev.A
Message Action
Bad OMR Code
length
Code type on paper does not match the set-
up. Example: setup has OMR+ Sequence but
paper has OMR + Select Feed + Sequence.
Bad OMR Code
format
A re-timing scan mark is missing. Check ma-
terial. Example: mark 6 is missing from a 10
mark code.
Expected 1st
Sheet of set
The BOC mark (position 4) was present when
it was not expected. First page of the set was
expected.
Not a new
Envelope
The BOC mark (position 4) was absent when
it was expected. Pages other than the first
page of the set were expected.
OMR: Parity Error The code does not have an EVEN number of
marks.
OMR: Sequence
Error
The sequence number is not sequential with
the previous page fed. Sheets are in the
wrong order or missing.
OMR: SF marks
Inconsistent
The Selective feed and Autobatch marks at
positions 7 to 9 are different from those on the
previous sheet of this set.
OMR: SF not in
Use
A selective feed mark is present at positions 7
to 8, but the job setup does not include select
feed.
OMR: Set too
Large
The set contains too many sheets from the
main feeder.
OMR: End of
Batch
Ready to Run
This indicates that the machine has stopped
for “End of Batch”. This allows the operator to
manually sort envelopes.
Mode Change
Recheck Feeders
Check the sheet and insert feeder settings
against the job you’re loading before exiting
the setup mode.