Pitney Bowes DI425 FastPac Inserting Systems - Manual (Page 41)

OMR • 3
3-3 SV61656 Rev.A
OMR Specifications
The mark must be a solid black line between 1pt and 2pts thick
(0.014 inch [0.35mm] to 0.027 inch [0.7mm]) and at least 0.393 inch
(10mm) wide.
Each mark position must be evenly spaced and at least 0.118 inch
(3mm) apart.
An area around the marks should be kept clear from print and any
other marks that might be read by the scanner in error. This area is
called the clear zone.
There should be no print on the opposing face of the sheet immedi-
ately behind the clear zone.
Note: Diagram is not to scale
1.65 inches (42mm)
maximum
0.118 inch (3mm)
minimum pitch
0.393 inches
(10mm)
minimum
1pt to 2pt
0.014 inch (0.35mm)
to
0.027 inch (0.7mm)
thick
0.078 inch
(2mm)
minimum
0.078 inch
(2mm) minimum
See diagrams on
pages 3-4 and 3-5
Clear Zone
See diagrams on
pages 3-4 and 3-5