Pitney Bowes DI425 FastPac Inserting Systems - Manual (Page 13)

Introduction • 1
1-7 SV61656 Rev. A
Insert Feeder — Use this feeder to add additional inserts to
your envelope. Material fed from this feeder cannot be folded
by the inserter. However, this feeder is especially suited to
feeding pre-folded or thicker inserts.
Fold Plates 1 and 2 — These create the desired fold in
material fed from the sheet feeder(s). The fold plates are auto-
matically set from the control panel.
Display/Control Panel — This is where you enter commands
and where the machine informs you of its status with the use
of symbols and icons. Each button function is explained on the
following page.
Drop Stacker or Output Device (not llustrated)
A fold down stacker is located at the exit from the machine
to collect the finished mail pieces. This unit can be latched
against the machine when not in use. Alternatively, a range of
power stackers are available which offer greater capacity than
the standard drop stacker.
A mailing machine interface can be installed in place of a
stacker. This device automatically transports mail pieces to a
Pitney Bowes mailing machine for postage imprinting.
Manual Advance Knob —The manual advance knob is locat-
ed inside an opening cover at the lower center of the machine.
Use it to turn the machine mechanisms by hand to help clear a
material stoppage.
Envelope Feeder — This feeder feeds envelopes into the
inserting area where they are filled with material requested
from the other feeder(s).
Sealer Bottle — The sealer bottle is located inside an opening
cover at the front right side of the machine. It provides sealing
solution to the envelope sealer.
Measuring Scale — The scale is located on the left side
of the machine near the sheet feeders. Use it as an aid in
measuring material and envelopes.
Envelope Inverter — This unit transports the envelope into
the stacker face up.
3
4
5
6
7
8
9
11
12
10