Pitney Bowes DI425 FastPac Inserting Systems - Manual (Page 22)

2 • Operation
2-6 SV61656 Rev. A
Setting the Envelope Feeder
The envelope feeder feeds the outer envelope for the inserting job
you’re running.
1. Adjust the side guides to the
width of the envelopes you’re
running, then back off half a
turn on the side guide control.
This sets the correct clear-
ance between the guides and
the envelopes.
2. Aerate (fan) the stack of en-
velopes you’re running.
3. Place envelopes on the feed
deck with their flaps up and
trailing.
IMPORTANT ! Check that
lead edge of the first enve-
lope is under the front feed
roller and that the stack of
envelopes is shingled on the
deck as shown.
Let the wedge slide down
behind the stack so that the
envelopes are supported.
Setting the Insert Feeder
1. Adjust the side guides to the
width of the material being
fed, then back off a quar-
ter turn on the side guide
control. This sets the cor-
rect clearance between the
guides and the material.