Pitney Bowes DI425 FastPac Inserting Systems - Manual (Page 37)

Operation • 2
2-21 SV61656 Rev. A
Testing the Job
Load material and press Trial Piece so that you can check if the
setup is correct.
You can make minor changes to the job settings at this stage if the
trial piece needs fine tuning. Press Setup, then use the Prev (◄),
Next (►) and Change (+/-) buttons as required to modify job set-
tings. The chart below will help you fine tune your fold settings.
FOLD TYPE ADDRESS TOO LOW ADDRESS TOO HIGH
C - Letter Fold Decrease Fold A Increase Fold A and
increase Fold B by
the same amount
Z - Accordion Increase Fold A Decrease Fold A a
Fold increase Fold B by
the same amount
Single Fold Increase Fold A Decrease Fold A
Double Fold Decrease Fold A Increase Fold A
We suggest that you change folds by 0.20 inches (5mm) each time
and run a new trial piece run to test the settings.
When you’ve made the necessary changes, press
Setup again to
return to run mode. The machine will save the job with the new set-
tings.