Pitney Bowes DI425 FastPac Inserting Systems - Manual (Page 34)

2 • Operation
2-18 SV61656 Rev. A
Fold B
Select the size of the second fold
required.
In a manner similar to that of fold
A, the machine suggests the cor-
rect dimension for the fold.
If you want to change the stan-
dard setting, press Change (+/-) until the length of fold required dis-
plays. The symbol | –––– | shows the fold panel you’re adjusting.
When the setting is correct, press
Next (►) to advance to the next
setting…
If you’re programming an inserting job, the envelope depth setting
now appears. If you’re programming a fold-only job, the display goes
straight to the Confirming the Job Setup section explained on page
2-20.
Envelope Depth
Select the depth of your enve-
lopes (in millimeters).
Again, you can use the scale on
the front cover to measure the
depth of your envelopes.
Press
Change (+/-) until the cor-
rect dimension is displayed.
When you’ve set envelope depth as required, press
Next (►) to go
to the next setting…