Pitney Bowes DI425 FastPac Inserting Systems - Manual (Page 11)

Introduction • 1
1-5 SV61656 Rev. A
Sheet Feeder 1 — This feeder is intended for feeding material
that requires folding.
In addition, you can set sheet feeder 1 to Manual Feed. In this
mode, you can run stapled sets of up to five sheets. The ma-
chine waits for each set to be manually fed into sheet feeder
1 before folding and inserting the set automatically. See the
Specfcatons section of this guide for full details of the sets
possible.
Sheet Feeder 2 — For feeding material that requires folding.
Its functions are similar to sheet feeder 1, but manual feed is
NOT available from this feeder.
1
2
Machine Identification
1
5
3 6
4
7
2
8
9
10
11
12