Pitney Bowes DI425 FastPac Inserting Systems - Manual (Page 18)

2 • Operation
2-2 SV61656 Rev. A
Select a Job
When the machine is turned ON,
the display shows the last job run
and “Trial Piece Required”.
Press the
Job button until the job
you require is displayed, or press
Default if you want to run the
machine with your standard job
settings.
Note: Only a Pitney Bowes Service Representative can modify the
default job.
If you have material loaded, press
Trial Piece. The machine sets
itself and runs a test piece for you
to check.
If you don’t have material loaded,
do this now, then return to this
section. Loading feeders and re-
lated instructions are covered on pages 2-4 to 2-7.
Note:
You may have selected a manual feed job where sheet feeder 1 is
set for manual feed of collated sets. If this is the case, DO NOT load
the sheet feeder; you will feed collated sets one at a time by hand as
required by the machine.
For manual feed jobs, pull back
the lever as shown in the illustra-
tion, right. This opens the feed
mechanism, making it ready for
manual feed operation.
Remember to return this lever to
its normal position when you use
the feeder for automatc opera-
tion.