HITEC Aurora 9X User Manual

Page 69

9 CHANNEL 2.4GHz AIRCRAFT COMPUTER RADIO SYSTEM

System Management Menu

Change to a Li-Po battery, the Li-Po Option

The nominal voltage of a two cell Li-Po or Lithium Polymer battery pack is 7.4V. The user has the option to power the Aurora 9X with a 2S
formatted Li-Po but accepts full responsibility to do so safely. To use a Li-Po transmitter battery safely, you must remove the battery from
the transmitter case for charging, and reinstall it after charging.

Change the battery choice from Ni-Cd or Ni-MH to Li-Po.

a. At the battery screen, press the

arrow

key.

b. You are asked to change to Li-Po, select

Yes

c. Here you can modify the transmitter alarm
voltage from 6.0V to 6.5V in 0.1V steps with
the

+RST –

icon.

DO NOT install a Li-Po in the Aurora 9X and then try to charge it with the supplied CG-S45 charger.
The CG-S45 was created for NiMH cells only! Major damage is sure to occur.

Caution

tiiiiiiiiiiiiiiiiiii

Many Li-Po manufacturers don’t recommend drawing the voltage of a cell below 3 volts.
A two cell Aurora 9X Li-Po battery pack should not spend much time at and below 6 volts.

{

Tip

The default is for a 7.2V Ni-Cd or Ni-MH.

i. Use the stylus to press and hold the mark
part for about 3 seconds.

K*GZPVDMJDLUIFBSSPXJDPOPOUIFSJHIUTJEF
PGUIFDIFDLGSFRVFODZ ZPVDBOTFUPOPò

L*GZPVDMJDLUIFBSSPXJDPOPOUIFSJHIUTJEF
UIFIJHIUISPUUMF ZPVDBOTFUUPPOPт