FeiYu Tech FY-Panda2 Autopilot - Manual (Page 51)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [email protected]
Page 49
speed, then push the aircraft into the air.
6 ) Wait the aircraft climb to 100m and circling around the Home point.
7 ) Through GCS to set , and wait the aircraft automatic climb to
200m.
8 ) Click on to start automatic navigation flight.
9 ) Wait the aircraft to fly according to the route you have set, then click on to
start automatic take photo.
10 ) Wait the aircraft complete the flight mission and cancel the automatic take photo
function.
11 ) Click on ,and wait the aircraft automatic return to home.
14.5 Firmware upgrade
Panda
Ⅱ contain the basic function of firmware upgrade, you can do the firmware upgrade by
yourself, just need to download the latest firmware from: www.feiyu-tech.com
Connection mode is as follows:
Firmware upgrade procedure:
1) Download the latest firmware and firmware upgrade software from our official website.
2) Install and open the firmware upgrade software, choose the right COM number and click on
―Open port‖.
3) Choose the firmware which you need to upgrade.
4) Start to upgrade, wait to upgrade success.
This manual is just a guideline to help you set up your aircraft for autonomous flight.
As each aircraft is unique, you will need to fine tune the settings to suit your aircraft‘s flight
characteristics.
----- END -----
Note: We reserve the right to change this manual at any time! And the newest edition will be shown
on our website www.feiyu-tech.com.