EXFO PM-1100 Optical Power Meter - Manual (Page 9)

Certification Information
Optical Power Meter v
Certification Information
F.C.C. Information
Electronic test equipment is exempt from Part 15 compliance (FCC) in
the United States. However, compliance verification tests are
systematically performed on most EXFO equipment.
Information
Electronic test equipment is subject to the EMC Directive in the European
Union. The EN61326 standard prescribes both emission and immunity
requirements for laboratory, measurement, and control equipment.
This unit has undergone extensive testing according to the European Union
Directive and Standards.
CSA Information
This unit is certified by the CSA (certificate number 162451) and was
evaluated according to applicable CSA and UL standards (as confirmed by
“C-US” mark) as well as applicable IEC standards for use in Canada, the
United States, and other countries.
Power Meter Performance Variation
In a 3 V/m radiated field (26 MHz to 1000 MHz, 80 % AM modulation with a
1 kHz sine wave) or with a conducted RF field of 3 V (0.15 MHz to 80 MHz,
80 % AM modulation with a 1 kHz sine wave), the emitted power may vary
by ± 0.1 μW.
I
MPORTANT
Use of shielded remote I/O cables, with properly grounded shields
and metal connectors, is recommended in order to reduce radio
frequency interference that may emanate from these cables.