EXFO PM-1100 Optical Power Meter User Manual
Ddendum

P/N: 1051923
January 2008
1/4
A
DDENDUM
This information applies only to the
PM-1100 Optical Power Meter user guide.
GPIB Commands and Queries
³
The FORM:READ:DATA? query does not exist.
³
The MMEM:ACQ:DATA:RECA:VALUE? query should be defined as
follows:
MMEMory:ACQuisition:DATA:RECAll:VALUE?
Description This query returns the measurement saved in the
memory location.
Syntax
MMEM:ACQ:DATA:RECA:VALUE?
Parameters The parameter represents the memory location where
measurement data is stored (out of the 1024 available).
Response
Measurement data saved in the specified memory location in
the “±999.999E±99” format.
Notes
³
Use the MMEM:ACQ:DATA:RECA:UNIT? query to get the
corresponding measurement units.
³
Use the MMEM:ACQ:DATA:RECA:WAVE? query to get the
wavelength at which the measurement was taken.
Example
MMEM:ACQ:DATA:RECA:VALUE? 1021
Document Outline
- Certification Information
- 1 Introducing the PM-1100 Optical Power Meter
- 2 Safety Information
- 3 Getting Started with Your Optical Power Meter
- 4 Operating the Optical Power Meter
- Cleaning and Connecting Optical Fibers
- Nulling Electrical Offsets
- Measuring Absolute Power
- Relative Power
- Average Mode
- Storing Data Manually
- Recalling Manually Stored Data
- Erasing Manually Stored Data
- Programming an Acquisition
- Starting the Acquisition
- Stopping the Acquisition
- Recalling Acquisition Data
- Erasing Acquisition Data
- Customizing Your Optical Power Meter
- 5 Controlling Your Optical Power Meter Remotely
- 6 Maintenance
- 7 Troubleshooting
- 8 Warranty
- A Technical Specifications
- B Remote Control Commands
- C SCPI-Based Errors
- Index