EXFO PM-1100 Optical Power Meter - Manual (Page 3)

P/N: 1051923 January 2008 3/4
³
The SENS:FREQ:CAT? query should be named and defined as follows:
³
The SENS:POW:WAV command should be named and defined as
follows:
³
The SENS:POW:WAV? query should be named and defined as follows:
SENSitivity:FREQuency:CATAlog?
Description This query returns a list of available sampling rates.
Syntax SENS:FREQ:CATA?
Response List of available sampling rates in the
“40.0;20.0;10.0;5.0;1.0;0.5;0.1” format.
Example SENS:FREQ:CATA?
SENSitivity:POWer:WAVElength
Description This command selects a new operating wavelength.
Syntax SENS:POW:WAVE [NM]
Parameters The is an operating wavelength expressed in
nanometers (nm). Any wavelength within the spectral range of
the optical detector (at 1 nm resolution) may be selected. See
the section on optical specifications in the user guide for the
exact spectral range of each detector type.
Example SENS:POW:WAVE 1310
SENSitivity:POWer:WAVElength?
Description This query returns the currently selected calibrated wavelength.
Syntax SENS:POW:WAVE?
Response The current wavelength in nanometers (nm) in the “9999 nm”
format.
Example SENS:POW:WAVE?