EXFO PM-1100 Optical Power Meter - Manual (Page 35)

Operating the Optical Power Meter
Optical Power Meter 25
Programming an Acquisition
4. Set the duration of the acquisition.
4a. Press ENTER. The first digit will start flashing. Use the up/down
arrows to change the flashing digit and the left/right arrows to
activate the next digit.
4b. Once the duration is set, press ENTER.
5. Press the right arrow. You will see the following display.
6. Set the number of samples to be taken during the acquisition.
6a. Press ENTER. The digit will start flashing. Use the up/down arrows
to toggle between the possible number of acquisitions (the
number of acquisitions the PM-1100 can store depends on the
duration you set at step 4).
6b. Once the number of samples is set, press ENTER.
7. To exit the Program menu, press Program.