EXFO FTB-610 Wideband Copper Test Module - Manual (Page 289)

Impulse Tests
Copper Test 281
Impulse Scope Test
The page allows you to set the following parameters:

Auto Ranging (Y-Axis) can be selected to make the y-axis (voltage)
dynamic, that is, scaled to fit the largest impulse height, for both trigger
modes.

Y-axis Range (Time Domain) is a pull-down list, when Auto Ranging
is turned off, allowing you to select a y-axis scale. Default is Use
current scale. If a previous/current scale is not available, for example
when first using the test, then the y-axis scale is set to -10 to +10 V,
however, the pull-down selection displays Use current scale.

Show Graph Insert allows you to remove the graph insert, when not
selected.

Graph Insert Location allows you to select where the graph insert is
placed on the page:

Top Left/Right

Bottom Left/Right

Graph Insert Size allows you to specify the Width and Height of the
graph insert.

Width value should be in the range of 250 to 400. Default is 250.

Height value should be in the range of 100 to 150. Default is 100.

Reset Graph Settings button restores the page to the default settings.
Summary
Summary tab displays the pass/fail status of the tests executed. Refer to
Copper Tests: Result Summary on page 291 for more information.