EXFO FTB-610 Wideband Copper Test Module - Manual (Page 241)

Signal Test
Copper Test 233
TX/RX Tone Test
Setting Test Parameters
The Test Parameters page allows you to set the parameter values for the
test.
To set the Parameter values:
1. From the Copper main menu Test Groups, select Signal test
.
2. From the Tests menu, select Balance test.
3. Tap Receive Tone tab for which you want to set the Parameter values.
4. Tap Edit Parameter button to open the Test Parameter page.
5. Set the Parameter values as required.
6. Tap Close to confirm and exit the page.
The page displays the following parameters:

Receive Tone allows you to select the Wideband Frequency or Voice
Frequency for the Receive tone.

Termination Resistance displays the termination resistance.
Summary
Summary tab displays the pass/fail status of the tests executed. Refer
Copper Tests: Result Summary on page 291 for more information.