EXFO FTB-610 Wideband Copper Test Module - Manual (Page 234)

Signal Test
226 FTB-610
WB Attenuation Test
Setting Cable Parameters
The Cable Selection page allows you to set cable parameters for the
Attenuation test.
To set the Cable Setup values:
1. From the Copper main menu Test Groups, select Signal test
.
2. From the Tests menu, select WB Attenuation test.
3. Tap Select Cable button to open the Cable Selection page.
4. Edit the Cable Parameters as required.
5. Tap Close to confirm and exit the page.
The page allows you to set or view the following parameters:

Cable Type allows you to select a cable entry (with its associated
parameters) from the current Cable Book, to use for testing. The
selection is not saved when leaving the test. The current Cable Book
entry is shown by default.

Cable Fill Material read-only entry is the type of material the cable is
filled with: Aircore, Jelly, Pulp, 5 PR, or 2 PR. Setup in the Cable Book.

Capacitance T-R specifies a value for the capacitance per length
constant.