EXFO FTB-610 Wideband Copper Test Module - Manual (Page 232)

Signal Test
224 FTB-610
WB Attenuation Test
Setting Test Parameters
The Test Parameters page allows you to set the parameter values for the
test.
To set the Parameter values:
1. From the Copper main menu Test Groups, select Signal test
.
2. From the Tests menu, select WB Attenuation test.
3. Tap Edit Parameter button to open the Test Parameter page.
4. Set the Bandwidth values as required.
5. Tap Close to confirm and exit the page.
The page allows you to set the following parameter:
Bandwidth sets the frequency range for the test.