Eurocom X8 - Manual (Page 229)

Modules
Trusted Platform Module 7 - 43
7
Enabling & Activating TPM
1. Restart the computer.
2. Enter the Aptio Setup Utility pressing F2 during the POST/startup.
3. Use the arrow keys to select the Security menu.
4. Select TPM Configuration and press Enter to access the sub-menu.
5. Press Enter to access the Security Device Support menu and select Enable to
display the full TPM configuration menu.
6. Select TPM State, press Enter and select Enable to change the TPM state to
enabled. You will then need to press F4 to save the changes and restart the
computer.
7. As the computer restarts press F2 to enter the BIOS again and go to the TPM
Configuration
menu.
Figure 7 - 30
TPM State
(Enabled)