Echelon i.LON 100 e2 Internet Server - Manual (Page 60)

4-18 Configuring the i.LON 100
Tone/Pulse This option only appears if you are using the
internal analog modem.
Set Tone or Pulse to determine whether the
i.LON 100 internal modem will dial-out using
touch-tone or pulse dialing. By default, this
option is set to Tone.
PIN Number This option only appears if you are using an
external modem.
Field Length: Up to 30 characters.
Set the PIN Number that must be send to the
external modem to send or receive calls.
Access Point Name
(APN) This option only appears if you are using an
external modem.
Field Length: Up to 64 characters.
Set the APN hostname required by most GPRS
service providers. This can be a valid IP address
or a valid hostname and domain suffix pair.
Quality of Service (QoS) This option only appears if you are using an
external modem.
Field Length: Up to 30 characters.
Set the QoS string required by most GPRS
providers.
Click Submit to save the changes you have made to this Web page. Click Reset
to set all fields on this Web page back to the values they had when the page was
opened.
Configuring L
ON
W
ORKS
Settings
If the i.LON 100 Internet Server will be used as a remote network interface to
facilitate communications between the local L ON W ORKS network and the LNS
Server, configure it by clicking Network on the title bar and selecting
L
ON W ORKS from the list on the left hand side of the page. The L ON W ORKS
Network Web page opens, as shown in the following figure: