Echelon FTXL Hardware - Manual (Page 66)

58 Working with the Altera Development Environments
a. Expand the Bridges and Adapters folder.
b. Expand the Memory Mapped folder.
c. Select Avalon-MM Tristate Bridge.
d. Click Add to open the MegaWizard for the component.
e. In the MegaWizard for the Avalon-MM Tristate Bridge, select
Registered on the Incoming Signals page. Click Finish to add the
component to the design.
6. Add the FTXL Parallel I/O Transceiver Interface component:
a. Expand the FTXL folder.
b. Select FTXL Parallel I/O Transceiver Interface.
c. Click Add to open the MegaWizard for the component.
d. In the MegaWizard for the FTXL Parallel I/O Transceiver
Interface, there are no parameters to set. Click Finish to add the
component to the design.
e. Connect FTXL_PIO_inst.avalon_tristate_slave_0 to
tristate_bridge.tristate_master.
7. Add the FTXL Service LED component:
a. Expand the FTXL folder.
b. Select FTXL Service LED.
c. Click Add to open the MegaWizard for the component.
d. In the MegaWizard for the FTXL Service LED, there are no
parameters to set. Click Finish to add the component to the
design.
8. Add the FTXL Service Pin component:
a. Expand the FTXL folder.
b. Select FTXL Service Pin.
c. Click Add to open the MegaWizard for the component.
d. In the MegaWizard for the FTXL Service Pin, there are no
parameters to set. Click Finish to add the component to the
design.
e. If necessary, modify the assigned IRQ number for the component;
see Addressing, Size, and IRQ Requirements on page 49 for
recommendations about the IRQ assignments.
9. Add the FTXL Transceiver Interrupt component:
a. Expand the FTXL folder.
b. Select FTXL Transceiver Interrupt.
c. Click Add to open the MegaWizard for the component.
d. In the MegaWizard for the FTXL Transceiver Interrupt, there are
no parameters to set. Click Finish to add the component to the
design.