Dillon Precision XL 650 - Manual (Page 37)

FIG 172
3. Swing the ejector wire back to its
original position over the shell-
plate and insert the shellplate bolt
FIG 172.
4. Using a 1/4” Allen wrench run the
shellplate bolt down until it stops
then loosen it slightly. Loosen it just
enough to allow the shellplate to
index freely.
FIG 173
5. Snug the shellplate set screw FIG
173.
FIG 174
Step 10) Install new locator pins FIG 174:
The new locator pins are located in your
caliber conversion kit.
1. Install as depicted
FIG 175
Step 11) Install the new Station 1 loca-
tor FIG 175:
The Station 1 locator is located in your
caliber conversion kit.
FIG 176
Step 12) Change the Body Bushing FIG
176:
The new body bushing is located in the
caliber conversion kit.
FIG 177
1. The body bushing is located on the
right side just above Station 1 FIG
177. Remove the body bushing by
slipping an Allen wrench through the
cross hole and twisting it counter-
clockwise.
2. Install the new body bushing.
FIG 178
Step 13) Replace the casefeed arm
bushing and casefeed
adapter FIG 178:
The new casefeed adapter and casefeed
arm bushing are located in your caliber
conversion kit.
38