Aiwa HV-MX100U - Manual (Page 5)

C A T V c o n i i L V t i o n s
To connect a CATV system without using a CATV converter
AC cord
(supplied)
CATV system
4_g3U)
75-ohm coaxial cable
(not supplied)
Antenna splitter (not supplied)
Connect the supplied antenna
cable to RF OUT of TUNER #2 on
the VCR and the antenna connector
on your TV.
If your TV has a 300-ohm antenna
connector, use an antenna splitter (not
supplied).
3
Set TUNER SELECT to #2.
Change the TUNER SELECT only when power is turned off.
When you change TUNER SELECT with the power turned on, the power will be cut off.
4 Connect the AC inlet of the VCR and the AC outlet with the supplied AC cord.
To VHF antenna
terminal
To UHF antenna terminal
To connect a CATV system using a CATV converter
CATV system
CATV converter
(not supplied)
AC cord
(supplied)
2
3
Connect the cable from the CATV
system to the input on the CATV
converter.
Connect the output on the converter
to AERIAL of TUNER #2 on this VCR.
Connect the supplied antenna cable to RF OUT of
TUNER #2 on the VCR and the antenna connector on
your TV.
If your TV has a 300-ohm antenna connector, use an antenna
splitter (not supplied).
4 Set TUNER SELECT to #2.
Change the TUNER SELECT only when power is turned off.
When you change TUNER SELECT with the power turned on, the power will be cut off.
5
Connect the AC inlet of the VCR and the AC outlet with the supplied AC cord.
To VFIF antenna
terminal
To UFIF antenna terminal
ENGLISH