Aiwa HV-MX100U - Manual (Page 28)

Using the VCR in other country
Connecting the VCR
This VCR can be used in every country other then France.
If you want to use the VCR in a PAL or SECAM area, connect the VCR and TV as foliows.
Be sure to attach a suitabie adaptor plug to the plug end of
the AC cord.
Adaptor plugs may be obtained at nominal cost from an
authorized AIWA dealer.
75-ohm coaxial cable
(not supplied)
AC cord (supplied)
ITUNERI
[
select ]
[TUNER^il
íг ^ m B/G 1 D/K
di [di
3 4
1 Disconnect the antenna from your TV --------------------------Audio/video cable_(supplied| -------------- ^
and connect it to AERIAL of TUNER #1 5
on this VCR.
2
Connect the optional antenna cable to RF OUT of TUNER #1 on the VCR and
the antenna connector on your TV.
3
Set TUNER SELECT to #1.
Change the TUNER SELECT only when power is turned off.
When you change TUNER SELECT with the power turned on, the power will be cut off.
When you select #1, the tuner switches to monaural.
4
Set TUNER #1 to select the tuner system, B/G, D/K, or I, according to your area.
5
If your TV has the audio/video input jacks, connect the VCR and TV using the
supplied audio/video cable.
6 Connect AC inlet of the VCR and the AC outlet with the supplied AC cord.
Tuner system of each area
To antenna
connector
To audio/video
input jacks
Area Tuner system
the United Kingdom, Hongkong,
South Africa
t
China, Russia, Eastern Europe D/K
Area Tuner system
Western Europe B/G
The East South Asia B/G
The Middle and Near East _ B/G
To connect a TV using a 21-pin scart cable
If your TV has a 21-pin scart connector, connect the VCR and the TV with an optional 21-pin
scart cable.
27 ENGLISH
21-pin scart cable
(not supplied)
To 21-pin
connector