TeeJet Matrix 840G User Manual - Manual (Page 44)

39
98-05188 R2 www.teejet.com
Curved A-B Guidance
Curved A-B Guidance provides guidance along curved lines based
on an initial A-B reference line. This initial baseline is used to
calculate all other guidelines.
Activate Curved A-B Guidance
1. Press the screen to activate the icons and select the GuidAnCe
Mode iCon .
2. Select Curved A-B GuidAnCe .
◄Status Bar icon will change to .
Figure 3-17: Guidance Mode Selection
Swath ha
0.0 0 0.0
Marking A and B Points
1. drive to the desired location of Point A .
2. While the vehicle is in motion, press MArk A iCon
A .
3. drive to the desired location of Point B .
4. Press the MArk B iCon
B to establish the A-B line.
NOTE: The MArk B ICON B is not available for selection (greyed
out) until the minimum distance is travelled (3.0 m).
use CAnCel MArk iCon to cancel the Mark A command and
revert to the previous A-B guideline (when established).
Figure 3-18: Mark A and B Points
km/h ha
1.20 10.5 Mark A
km/h ha
2.60 10.5 Mark B
The console will begin providing navigation information.
Figure 3-19: Curved A-B Guidance
Swath ha
8.96 -1 3.2
A+ Nudge Feature
The A+ nudge feature allows the existing A-B guideline to be shifted
to the vehicle’s current location.
1. Press A+ nudGe iCon
A to establish the new guideline.
Figure 3-20: A+ Nudge
Swath ha
3.80 -2 5.1
Swath ha
3.81 -2 0.0
Circle Pivot Guidance
Circle Pivot guidance provides guidance around a central location
that radiates inward or outward. it is used for product application in
a centre pivot field while being guided along a circular guideline that
matches a centre pivot irrigation system radius.
Activate Circle Pivot Guidance
1. Press the screen to activate the icons and select the GuidAnCe
Mode iCon .
2. Select CirCle PivoT GuidAnCe .
◄Status Bar icon will change to .
Figure 3-21: Guidance Mode Selection
Swath ha
0.0 0 0.0