TeeJet Matrix 840G User Manual - Manual (Page 13)

●
8
Start Up Sequence
The console takes approximately 40 seconds to power up. During
this time the TeeJet Technologies logo will be displayed (LEDs will
power on and off and brightness levels will fluctuate.)
Figure 1-20: Power Up Screen
Once the power up sequence has cycled, the following message is
displayed:
“Would you like to clear the job data and begin a new job?”
1. Press
►No – The previous job will resume.
►Yes – A new job will be established and all data from previous
jobs will be cleared. The message “All job data cleared” is
displayed. Select “OK” to continue.
The splash screen will be displayed for approximately one minute.
The splash screen lists the module’s current software version. The
information is also available on the About screen.
NOTE: A firm touch is required when selecting or acknowledging a
screen option.
Figure 1-21: Clear Job Data Screens Figure 1-22: Splash Screen
Matrix
v1.0
General OperatiOn infOrmatiOn
A firm touch is required when selecting a screen icon.
On initial startup, the console will load the Vehicle View screen as
a default. All subsequent power cycles will return to the last page
viewed before powering down.
Icons on guidance screens will be displayed and will fade from the
window after 6 seconds of inactivity. To regain these icons, touch the
screen in any location.
Figure 1-23: With and Without Icons On Screen
Press the icon of any menu item to display a definition of that item.
To remove the information box, press anywhere on the screen.