TeeJet TASC-6600 - Manual (Page 7)

1-1
TASC-6000, 6300, 6600 98-05010
Rev. - 1
1.0 SWITCHES AND CONTROLS
MID-TECH
MIDWEST TECHNOLOGIES, INC.
CHEMICAL APPLICATORS
1 2 3
ON
OFF
Alt.-
Rate
TASC-6600
TOTAL APPLICATION
SPRAYER CONTROL
%Rate
DISPLAY SELECTOR
Speed
Area Width
Distance
Chem. Applied
Test
Speed
Prime
Total Applied
Chem. Rate Appl. Rate
CHEMICALS CARRIER
OFF SET- UP DEC.
ON OPERATE INC.
1 2 3 4 5 6 7 8 9
BOOMS
Scan
4 5 6
.
-Ac
Flow
RATE
Gal./
®
Display
Mode Selector
Switch
Power Switch Increase/Decrease
switch
Display
Selector
Switch
Boom Indicators Injection Pump Switches
1.1 POWER SWITCH
The power switch controls power to the console. The console has an "Auto Power Down" feature which powers the
console off after an operator selectable time (default is 30 min) has elapsed. The console has a nonvolatile memory so it
"remembers" the constants and data previously entered, even if the power is removed.
NOTE: The “Auto Power Down Feature is only available on the CE version of the console (CE designation label on back
of console).
1.2 MODE SELECTOR OPERATE/SET- UP SWITCH
The Mode Selector switch (upper right) is used to switch between the OPERATE and SET-UP modes. When spraying,
this switch must be in the OPERATE position. The SET- UP position is used for entering information into the console.
In the SET-UP Mode, all pump operations (except calibration) are turned off and an Err message appears if a position
which can not be programmed is selected.
1.3 INC/DEC SWITCH
The INC/DEC switch (upper right) is used to adjust the values appearing in the display. The INC/DEC switch is used in
both OPERATE and SET-UP Modes.
This switch is also used to zero the accumulated areas, distance, and volumes by selecting the desired display and
holding this switch in the DEC position until the display resets to zero, (approximately 3 sec).
1.4 DISPLAY SELECTOR
The Display Selector (right center) is used to select the various console functions that are to be displayed and adjusted.