TeeJet TASC-6600 User Manual
Page 33
3-5
TASC-6000, 6300, 6600
98-05010
Rev. - 1
3.8. MANUAL OVERRIDE OF FLOW CONTROL VALVE
There may be times when it will be necessary to control the product flow manually (To run "Speed & Pressure", unload
the carrier tank, etc.).
A. To enter this mode do the following:
MODE SELECTOR SWITCH
CARRIER APPL. RATE
MODE SWITCH
SETUP
Use INC/DEC SWITCH to set rate to 0.0
MODE SWITCH
OPERATE
B. Console reads "Flow Contl OFF Auto".
In this mode the Flow Control Valve only responds to the INC/DEC Switch. The valve moves toward full open as long
as the INC Switch is being held up. Holding the DEC Switch down moves the valve toward full closed.
When in Manual Mode, carrier flow rate is monitored by turning the Display Selector to "Carrier Application Rate". The
flow rate reads out in gallons per minute, when the actual ground speed is less than one MPH, and in gallons per acre
when ground speed is above one MPH.