TeeJet TASC-6600 User Manual
Page 45
6-3
TASC-6000, 6300, 6600
98-05010
Rev. - 1
E. Turn ON the desired chemical injection pumps, to the rate desired, proceed to the application area, accelerating
to normal spraying speed. When the vehicle reaches the starting point of the desired swath, turn on the appro-
priate boom switches and the sprayer starts to spray. At this point, the operator is enjoying all monitoring
functions of TASC, with the exception of Carrier Application Rate and automatic control of the flow control
valve. The console is not able to adjust carrier flow based on speed and boom width changes. The operator must
drive at the correct speed and readjust the pressure manually if the boom width changes.
F. All volumes and areas, with the exception of CARRIER, TOTAL APPLIED, accumulate normally. The
chemical injection pumping rates respond normally to changes in boom configuration, ground speed or pump
application rate changes commanded by the operator. The carrier flow rate will read 0.0
G. To exit the Manual Override Mode reenter some Carrier Application Rate, other than zero, into the console.