TeeJet TASC-6600 User Manual
Page 13
2-1
TASC-6000, 6300, 6600
98-05010
Rev. - 1
2.0 CALIBRATION AND SET UP
The TASC Control Console must be calibrated for the various sensors used and programmed with certain information
before it is ready to be used. The calibration and set up processes are not difficult, however; they must be followed
precisely in order to get maximum accuracy out of the system.
2.1 ENGLISH AND METRIC UNITS
The TASC Control Console is capable of operating in two different units of measure, English and Metric.
2.1.1 UNITS FOR EACH POSITION
(Refer to Appendix D for these units in "Handgun Mode".)
FUNCTION
U.S.
METRIC
Speed
Miles/Hour (MPH)*
Kilometers/Hour (KPH)*
Area
Acres (-Ac)*
Hectares (-Ha)*
Chem. Applied
Ounces-U.S. Gallons (TOTAL/Oz)*
#
Liters (TOTAL/Liters)*
#
Chem. Rate
Ounces/Acre (Oz-Ac)*
@
Liters/Acre (RATE/Liters-Ha)*
@
Appl. Rate
U.S. Gallons/Acre (Flow/RATE
Liters/Hectare (Flow/RATE/
GAL./ -Ac)*
Liters-Ha)*
Total Applied
U.S. Gallons (TOTAL/Flow/Gal.)*
Liters (TOTAL/Flow)*
Width
Inches-Feet (TOTAL/Boom/Ft.)*
Meters (TOTAL/Boom/Meters)*
Distance
Feet-Miles (Dist./Ft.)***
Meters-Kilometers (Dist.)*
Prime
Ounces (Oz)
Liters (Liters)
Test Speed
Miles/Hour (MPH)
Kilometers/Hour (KPH)
* Items in parenthesis are the abbreviations that appear on the screen.
** No units displayed
*** No units displayed after roll over of feet to miles or meters to kilometers
#
TOTAL when channel in Non-Peristaltic
@
-Ac when channel is in Non-Peristaltic
2.1.2 CHANGING UNITS
To change units, set the Mode switch to OPERATE and the Display Selector to SPEED. The current speed units are be
displayed. Holding the INC/DEC switch down for approximately 5 sec.causes the display to alternate between U.S and
Metric modes (MPH and KPH). The mode being displayed when the INC/DEC switch is released will be selected.
2.2 PERISTALTIC AND NON-PERISTALTIC INJECTION PUMP MODES
Settingg Channel 1 - 6 Drive Method (TASC 6300/6600 Only)
The TASC 6300 and 6600 Chemical Applicator channels (1 - 6) can use two different drive methods, depending on the
type of equipment being controlled by the individual channel. "Peristaltic Drive" is used for peristaltic injection pumps.
"Non-Peristaltic Drive" is for future development. You should select the "peristaltic" drive method at this time.
NOTE: PLEASE READ THROUGH THE FOLLOWING SECTIONS
COMPLETELY BEFORE YOU BEGIN CALIBRATION!