SilentKnight 5104 Digital Alarm Communicator Transmitter 6 Zone - Manual (Page 29)

Model 5104B Installation Manual 151053-L8
5-2
5.2 5230 Touchpad Functions
There are several key functions used on the 5230 to input to the 5104, which are described in Table 5-
2. However, as the 5230 is used with other control panels, not all the key function apply to the 5104.
Trouble Remote # (1-3) One or more 5230 annunciators are in trouble. The 5230 ID number is indicated
in the # place.
EEPROM Sum Error Error during program mode.
Low Battery Battery voltage is less than 10.2 VDC.
Trouble Smk Pwr Smoke loop power is less than 10 V or an overcurrent condition exists.
Bell Trouble Trouble condition on the notification circuit.
Trouble Com 1 Auto test or manual test unable to report on line 1.
Trouble Com 2 Auto test or manual test unable to report on line 2.
Supervisory # (1-6) Alarm condition on the zone programmed as the sprinkler zone.
Table 5-2: Touchpad Keystrokes and Their Task or Function
Task or Function Keystroke
Enter function or data.
Used initiate any command or to enter a step parameter
into programming memory. . See examples below.
Enter Program Mode.
Installer Code.
Set Time.
Installer Or Operator Code.
Manual Test.
Sends a phone test to central station. Installer or Operator Code
followed by the time in military (24 hr clock).
Clear.
Used to delete the most recent key sequence from
annunciator memory. Used to correct an incorrect entry.
Shift.
Used with other keys to enter alpha-numeric values.
This key is labeled Disable/Shift, but is only used as a
shift task.
Silence.
Used to silence audible trouble or alarm annunciations.
Note: Trouble or supervisory annunciations will be si-
lenced immediately when you press the silence key followed
by the installer or operator code. Silences notification output,
while 5230 remains audible.
Installer or Operator Code.
Table 5-1: 5230 LCD Messages and Meanings
Message Meaning
ENTER
7
ENTER
SET
9
TIME ENTER
0
TEST ENTER
CLEAR
DISABLE
SHIFT
SILENCE
STEP