3 demo kit contents, 4 demo board versions, 5 compatibility – Maxim Integrated 71M6541 Demo Board User Manual
Page 6: 6 suggested equipment not included, Demo kit contents, Demo board versions, Compatibility, Suggested equipment not included
71M6541 Demo Board REV 3.0 User’s Manual
6
Rev 4.0
1.3 DEMO KIT CONTENTS
•
Demo Board D6541 REV 3.0 containing one 71M6601 or 71M6201 Remote Sensor Interface and one
71M6541F IC with pre-loaded demo program
•
5VDC/1,000mA universal wall transformer with 2.5mm plug (Switchcraft 712A compatible)
•
Serial-USB converter
•
USB cable
•
ANSI base with 50
μΩ shunt resistor (optional, for ANSI kits only) or two 120 μΩ shunt resistors
1.4 DEMO BOARD VERSIONS
This manual applies to D6541 REV 3.0 only.
1.5 COMPATIBILITY
This manual applies to the following hardware and software revisions:
•
71M6541 chip revision B02
•
Demo Kit firmware revision 5.4G or later
•
Demo Board D6541 REV 3.0
1.6 SUGGESTED EQUIPMENT NOT INCLUDED
For functional demonstration:
•
PC with Windows® 2000, Windows XP®, or Windows 7 operating system, equipped with USB port.
For the use of the optional Debug Board, a serial interface (COM port) is required.
For software development (MPU code):
• Signum
Systems
In
-
Circuit Emulator
(ICE
): ADM-51
o
Signum WEMU51 version 3.11.09 or later should be used.
• Keil 8051 “C” Compiler
K
it: CA51
Windows and Windows XP are registered trademarks of Microsoft Corp.