Maxim Integrated 71M6541 Demo Board User Manual
Maxim Integrated Hardware
Maxim Integrated cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim Integrated product. No circuit patent
licenses are implied. Maxim Integrated reserves the right to change the circuitry and specifications without notice at any time.
Maxim Integrated 160 Rio Robles, San Jose, CA 95134 USA 1-408-601-1000
© 2012 Maxim Integrated Products, Inc. Maxim Integrated and the Maxim Integrated logo are trademarks of Maxim Integrated Products, Inc.
71M6541 Demo Board REV 3.0
User’s Manual
Rev 4.0; 12/12
Table of contents
Document Outline
- 1 GETTING STARTED
- 1.1 GENERAL
- 1.2 SAFETY AND ESD NOTES
- 1.3 DEMO KIT CONTENTS
- 1.4 DEMO BOARD VERSIONS
- 1.5 COMPATIBILITY
- 1.6 SUGGESTED EQUIPMENT NOT INCLUDED
- 1.7 DEMO BOARD TEST SETUP
- 1.8 USING THE DEMO BOARD
- 1.8.1 SERIAL COMMAND LANGUAGE
- 1.8.2 USING THE DEMO BOARD FOR ENERGY MEASUREMENTS
- 1.8.3 ADJUSTING THE KH FACTOR FOR THE DEMO BOARD
- 1.8.4 ADJUSTING THE DEMO BOARDS TO DIFFERENT SHUNT RESISTORS
- 1.8.5 USING THE PRE-AMPLIFIER
- 1.8.6 USING CURRENT TRANSFORMERS (CTs)
- 1.8.7 IMPLEMENTING A SINGLE-PHASE 3-WIRE METER (EQU 1)
- 1.8.8 ADJUSTING THE DEMO BOARDS TO DIFFERENT VOLTAGE-DIVIDERS
- 1.9 CALIBRATION PARAMETERS
- 1.10 DEMO CODE
- 2 APPLICATION INFORMATION
- 3 HARDWARE DESCRIPTION
- 4 APPENDIX