Casio EA-200 - Manual (Page 44)

20031201
Saving Sample Data
The data produced by an EA-200 sampling operation controlled from the E-Con EA-200
application is stored temporarily in the ClassPad’s [EConSamp] folder. This temporary data
is called the “current data”.
• Current data is saved using one or more variables, one for each of the channels that was
used for sampling. Variable names are assigned automatically in accordance with the
channel and sensor used for sampling.
Variable Name Channel and Sensor Used for Sampling
CH1 CH1
CH2 CH2
CH3 CH3
SONIC SONIC
MIC EA-200’s built-in microphone
Current data is saved under this variable whenever either of the
following sensor settings is selected.
• [CASIO] - [Microphone]
• [CASIO] - [Speaker (Sample Data)]
FFT EA-200’s built-in microphone
Current data is saved under this variable whenever either of the
following sensor settings is selected.
• [CASIO] - [Microphone-FFT]
• [CASIO] - [Microphone], with the [FFT Graph] setting turned on
• [Vernier] - [Microphone], with the [FFT Graph] setting turned on
Performing a sampling operation when [CASIO] - [Microphone] is selected on the Sensor
Setup window and the [FFT Graph] setting is turned on simultaneously creates two sets of
current data with variable names “MIC” and “FFT”.
• The current data is displayed on the [Current] tab of the E-Con Graph Editor window in the
format .
5-5
Executing a Sampling Operation
Sample Display