beautypg.com

5 executing a sampling operation, Starting the sampling operation, 5 executing a sampling operation -1 – Casio EA-200 User Manual

Page 40: Starting the sampling operation -1

background image

20031201

5-1

Executing a Sampling Operation

5 Executing a Sampling Operation

This chapter explains the procedure for executing an EA-200 sampling operation in
accordance with E-Con EA-200 application settings. It also explains how to store sample
data collected with the EA-200

Note

• For information about operation when [CASIO] - [Speaker ( y = f (x))] is selected as the

sensor on the Sensor Setup window, see “6 Outputting a Function to the Speaker”. When
[CASIO] - [Speaker ( y = f (x))] is selected, sampling is not performed. Instead, the sound of
the waveform of a function input on the ClassPad is output from the EA-200’s speaker.

u To get ready for sampling

(1) Connect the EA-200 to your ClassPad.

(2) Turn on the EA-200.

(3) Connect the required sensor(s) in accordance with the setup you will be using for the

sampling operation.

(4) Set up the sampling environment with the material to be sampled, required equipment,

etc.

Starting the Sampling Operation

This section explains how to start the sampling operation, and describes the entire sampling
procedure right up to the end.

u To start a sampling operation

(1) On the Sensor Setup window, select either the [Single] tab or the [Multiple] tab, in

accordance with the type of sampling you want to perform.

• You can also recall previously saved setup data (page 4-2).

(2) To start sampling, tap V.

• This displays a dialog box like the one shown below.

If the warm-up time setting is anything other than “0 sec”, this dialog box appears
after warm-up is complete

• Tapping [OK] on this dialog box starts sending the setup data on the currently

displayed Sensor Setup window tab ([Single] or [Multiple]) to the EA-200.

• You can cancel the sampling operation by tapping [Cancel].