Casio EA-200 - Manual (Page 21)

20031201
3-2
Setup
Configuring Advanced Sampling Parameters
This section explains how to configure advanced sampling parameters on the [Sample] and
[Trigger] tabs of the Setup dialog box.
u To configure advanced parameters for a single sensor
(1) Perform steps (1) through (6) under “To configure parameters for sampling with a single
sensor” on page 2-1.
(2) On the menu bar, tap [Setup].
• This displays the [Sample] tab of the Setup dialog
box.
• The initial [Mode] setting is the mode that matches the sensor that was selected on
the [Single] tab.
(3) Use the [Mode] box to select the mode you want.
• For more information about modes, see “Modes” on page 3-3.
• Selecting a mode causes the applicable parameters to appear on the [Sample] and
[Trigger] tabs.
(4) Use the [Sample] and [Trigger] tabs of the Setup dialog box to configure the required
parameters.
• For details about the required parameters in each mode, see “Mode Parameters” on
page 3-5.
(5) After everything is the way you want, tap [Set].
• This applies your settings and closes the Setup dialog box.