Casio EA-200 - Manual (Page 17)

20031201
Configuring Parameters for Sampling with Multiple Sensors
Use the [Multiple] tab to configure parameters for simultaneous sampling with multiple
sensors. The [Multiple] tab lets you select up to three channels for sampling, from among the
EA-200’s CH1, CH2, CH3, and SONIC channels.
u To configure parameters for sampling with multiple sensors
(1) Start up the E-Con EA-200 application.
• This displays the [Single] tab of the Sensor Setup window.
• If the E-Con EA-200 application is already running and another window (besides the
Sensor Setup window) is displayed, tap C to change to the Sensor Setup window.
(2) Tap the [Multiple] tab.
• This displays the [Multiple] tab, which appears as
shown to the right.
(3) Tap inside the box of one of the sensors you want to
select ([CH1], [CH2], [CH3], [SONIC]).
• This causes a Select Sensor dialog box like the one
shown to the right to appear. The dialog box shown
here is for CH1, CH2, and CH3.
2-7
Basic Steps for Configuring Sampling Parameters