Casio EA-200 - Manual (Page 4)

20031201
1-1
E-Con EA-200 Application Overview
1 E-Con EA-200 Application Overview
This chapter describes the configuration of the E-Con EA-200 application screen, and
provides basic information about its menus and commands.
Starting Up the E-Con EA-200 Application
u ClassPad Operation
(1) On the ClassPad application menu, tap the down arrow in the upper right corner and
then select [Additional] or [All] from the dropdown list.
(2) On the application menu, tap .
This starts up the E-Con EA-200 application and displays a Sensor Setup window.
E-Con EA-200 Application Windows
The E-Con EA-200 application has three windows: a Sensor Setup window, an E-Con Graph
Editor window, and an E-Con Graph window. Only the Sensor Setup window is visible when
you start up the E-Con EA-200 application. You can have any two of the three windows
(Sensor Setup, E-Con Graph Editor, E-Con Graph) displayed at the same time.
In addition to the three windows described above, there is also a Multimeter window, which
appears on the screen during certain operations.
Sensor Setup window Multimeter window
E-Con Graph Editor window E-Con Graph window
{
{
Menu bar
Toolbar
20040201