Interlogix NS3500-28T-4S User Manual - Manual (Page 298)

298
frame that hits this ACE matches this destination IP address value.
 Destination IP
Wildcard Mask
When "User Defined" is selected for the destination IP filter, you can enter a
specific DIP mask in dotted decimal notation.
 Source Port Specify the source port for this ACE.

Any : No specifc source port is specified (source port status is "don't-care").

Single : If you want to filter a specific source port with this ACE, you can
enter a specific source port value. A field for entering a source port value
appears. The allowed range is 0 to 65535. A frame that hits this ACE
matches this source port value.

Range : If you want to filter a specific source port range filter with this ACE,
you can enter a specific source port range value. A field for entering a
source port value appears. The allowed range is 0 to 65535. A frame that
hits this ACE matches this source port value.
 Destination Port Specify the destination port for this ACE.

Any : No specifc destination port is specified (destination port status is
"don't-care").

Single : If you want to filter a specific destination port with this ACE, you
can enter a specific destiantino port value. A field for entering a destiantino
port value appears. The allowed range is 0 to 65535. A frame that hits this
ACE matches this destination port value.

Range : If you want to filter a specific destiantion port range filter with this
ACE, you can enter a specific destiantion port range value. A field for
entering a destination port value appears.
UGR Specify the TCP "Urgent Pointer field significant" (URG) value for this
ACE.

Set : TCP frames where the URG field is set must be able to
match this entry.

Unset : TCP frames where the URG field is set must not be able
to match this entry.

Don’t Care : Any value is allowed ("don't-care").
 TCP Flags
ACK Specify the TCP "Acknowledgment field significant" (ACK) value for
this ACE.

Set : TCP frames where the ACK field is set must be able to
match this entry.

Unset : TCP frames where the ACK field is set must not be able