Interlogix NS3500-28T-4S User Manual - Manual (Page 143)

143
blocking state.
The following are the user-configurable STP parameters for the port or port group level:
Variable Description Default Value
Port Priority A relative priority for each
port –lower numbers give a higher priority
and a greater chance of a given port being
elected as the root port
128
Port Cost A value used by STP to evaluate paths –
STP calculates path costs and selects the
path with the minimum cost as the active
path
200,000-100Mbps Fast Ethernet ports
20,000-1000Mbps Gigabit Ethernet
ports
0 – Auto
Default Spanning-Tree Configuration
Feature Default Value
Enable state STP disabled for all ports
Port priority 128
Port cost 0
Bridge Priority 32,768
User-Changeable STA Parameters
The Switch’s factory default setting should cover the majority of installations. However, it is advisable to keep the
default settings as set at the factory; unless, it is absolutely necessary. The user changeable parameters in the Switch
are as follows:
Priority – A Priority for the switch can be set from 0 to 65535. 0 is equal to the highest Priority.
Hello Time – The Hello Time can be from 1 to 10 seconds. This is the interval between two transmissions of BPDU
packets sent by the Root Bridge to tell all other Switches that it is indeed the Root Bridge. If you set a Hello Time for
your Switch, and it is not the Root Bridge, the set Hello Time will be used if and when your Switch becomes the Root
Bridge.
The Hello Time cannot be longer than the Max. Age. Otherwise, a configuration error will
occur.
Max. Age – The Max Age can be from 6 to 40 seconds. At the end of the Max Age, if a BPDU has still not been
received from the Root Bridge, your Switch will start sending its own BPDU to all other Switches for permission to