IC Realtime 4/8 All Channel 720P Mini 1U HD-AVS DVR - Manual (Page 35)

26
Here you can check the mark information item you want to delete and then click Delete button, you can
remove one mark item. .
Note
 After you go to the mark management interface, system needs to pause current playback. System
resume playback after you exit mark management interface.
 If the mark file you want to playback has been removed, system begin playbacking from the first file
in the list.
4.5 Schedule
After system booted up, it is in default 24-hour regular mode. You can set record type and time in
schedule interface.
4.5.1 Schedule Menu
In the main menu, from setting to schedule, you can go to schedule menu. See Figure 4-13.
 Channel: Please select the channel number first. You can select “all” if you want to set for the
whole channels.
 Week day: There are eight options: ranges from Saturday to Sunday and all.
 Pre-record: System can pre-record the video before the event occurs into the file. The value ranges
from 1 to 30 seconds depending on the bit stream.
 Redundancy: System supports redundancy backup function. It allows you backup recorded file in
two disks. You can highlight Redundancy button to activate this function. Please note, before enable
this function, please set at least one HDD as redundant. (Main menu->Advanced->HDD
Management) Please note this function is null if there is only one HDD.
 Snapshot: You can enable this function to snapshoot image when alarm occurs.

Record types: There are four types: regular, motion detection (MD), Alarm, MD & alarm.
 Holiday setting: Click it you can see an interface shown as in Figure 4-14. Here you can set holiday
date. Check the box, it means current channel shall record as your holiday setup. Please go to the
Period interface to set the holiday date record setup. Please note you need to go to Chapter 5.3.1 to
enable Holiday function first.
Please highlight icon to select the corresponding function. After completing all the setups please
click save button, system goes back to the previous menu.
At the bottom of the menu, there are color bars for your reference. Green color stands for regular
recording, yellow color stands for motion detection and red color stands for alarm recording. The
white means the MD and alarm record is valid. Once you have set to record when the MD and alarm
occurs, system will not record neither motion detect occurs nor the alarm occurs.