FingerTec TCMS V2 (Abridged Vesion) User Manual
Page 26
27
GENERAL TAB
DONE
If in the scenario above, the employee can do Overtime after
his working hours, define the
Separation hours between an out
clocking…
Note: Only choose to use in accordance to your company policies.
Alternatively for the two scenarios above, define the
Separation
hours between an out clocking…
Note: Only choose to use in accordance to your company policies.
If you want only the first transaction in a time interval to be
displayed, define the
Double punch for consecutive clocking…
Note: Only choose to use in accordance to your company policies.
ROUNDING TAB
DONE
Define
Round up the work time to nearest (minutes)
Choose
Rounding
calculation type.
Note: Only choose to use in accordance to your company policies.
Define
Round up the OT time to nearest (minutes)
Choose
Rounding
calculation type.
Note: Only choose to use in accordance to your company policies.
Define
First rounding time range
Choose the time that it should
round to
.
Note: Only choose to use in accordance to your company policies.
Define
Last rounding time range
Choose the time that it should
round to
.
Note: Only choose to use in accordance to your company policies.
BREAK TAB
DONE
If your company wishes to deduct break time from total work time,
click
Yes
on
Ignore Break Time
.
If your company does not employ this practice, ignore the checker
and go to the next tab (
Overtime
)
Configure lunch time duration.
Configure dinner time duration.
If your company wishes to apply Auto Add Break Rule, click
Yes
on
the relevant checker.
If your company pays for employees’ breaks, click
Yes
on the relevant
checker.
If your company wishes to include lunch/dinner time into overtime
hour, click
Yes
on the relevant checker.
If your company wishes to Deduct Whole break time if employee
exceeds given break time, click
Yes
on the relevant checker.
If applicable, specify the number of hours of break time that will be
deducted from the overtime hour if the overtime hour exceeds a
specified value.