FingerTec TCMS V2 (Abridged Vesion) - Manual (Page 20)

21
The Clocking Schedule window, with the Rounding tab chosen
5.3 ROUNDING
Rounding is to determine the rounding of minutes rule allowed in the clocking
schedule and the rules will determine the presentation of time in the attend-
ance sheet.
5.3.1 Rounding total work time and overtime
Up : Work time and overtime recorded is rounded up to the nearest
minute. E.g.: if Round to nearest minute is set to 15, all minutes will be
rounded up as per below:
1-15 minutes = 15, 16-30 minutes = 30, 31-45 minutes = 45, 46-59 min-
utes = 1 hour
Down: Work time and overtime recorded is rounded down to the
nearest minute. E.g.: if Round to nearest minute is set to 15, all minutes
will be rounded down as per below:
1-15 minutes = 0, 16-30 minutes = 15, 31-45 minutes = 30, 46-59 minutes
= 45
Midpoint: Work time and overtime recorded is rounded according to
the midpoint calculated. E.g.: if Round to nearest minute is set to 15,
the midpoint is 7 and the clocking schedule’s IN time is 9:00 am.