Press [enter, Press [enter] again – Toshiba D-VR610KU User Manual

Page 43

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Press [ENTER].

"To Standby Mode" is highlighted.

Press [ENTER] again.

In a second, the unit will be turned off

automatically as it goes into the satellite link
standby mode.

To cancel the satellite link function while in
the satellite link standby mode:

Press [TIMER SET] to turn on the unit.

To cancel the satellite link function while the
satellite link recording is in progress:

Press [BSTOP] or EJECT /■ STOP] on the

front panel of the unit.

Note

i • If the signal of external input breaks up over 5 seconds, satellite link function will be canceled.

• If you have not set the clock, "Clock Setting" menu will appear at step 1. Follow to step 3 in "Clock Setting" on

I page 26.

■'

'' V■

■':■

J • You cannot set the end time for the satellite link timer recording on this unit.

• Recording picture will be distorted if the copy protection signal is being detected during satellite link timer

recording.

• You can record the satellite link by using S-video input jacks on the rear panel. Refer to page 19 for more

information.

• Press [TIMER PROG.] during the satellite link timer recording to check the satellite link timer recording in

progress.

• When a regular timer recording and the satellite link timer recording are overlapped, those recordings are

;

recorded as illustrated below.

EN 43