Connection to an external tu, En 19, C i^l 0ci o o 10" 0« o – Toshiba D-VR610KU User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONNECTION TO AN EXTERNAL TU
This section describes how to connect this unit to an external tuner such as cable/satellite box.
• When you change the connections, all devices should be turned off.
• Refer to the operation manual accompanying external devices for more information.
1
Disconnect the power cords of the devices from the AC outlet.
o
c
o
3
Make the connection as illustrated below.
e.g.)
tf
rear of your TV
RF coaxial cable
DVDA/CR
\
S-VIDEO
IN-AUDIO-OUT
-c
I^L
0CI
o o
10" 0«
o
IN-VIDEO-OUT
0 0*
cable
RCA video cable
.......
f
S-VIDEO VIDEO r AUDIO OUT D
OUT OUT
1 L R 1
@ ® ®
' TV signal
rear of this unit
S-video cable!
RCA video cable
external tuner
RCA audio cable
Supplied cables used in this connection are as follows:
* RCA audio cable (L/R) x 1
* RCA video cable x 1
Please purchase the rest of the necessary cables at your local store.
m
&
m
m
\ c
3
3
m
A
o
i
2
a*
m
• Required cables and connecting methods differ depending on the external tuner.
For more information, please contact your external tuner provider.
• Instead of using VIDEO OUT jack of this unit, you can also use S-VIDEO OUT jack, COMPONENT VIDEO OUTPUT
jack, or HDMI OUT jack (no AUDIO OUT jack connection required) for connecting to your TV.
With this setup:
• You can record any unscrambled channel by selecting the channel on the external tuner. Be sure that the external
tuner is turned on,
• Signal from the external tuner can be output only on CVBS output even when the power of the unit is off.
• You cannot record one channel while watching another channel.
I 3
I
^
c
3
' A
Í
o‘
3
£
<
A
»
•n
c
3
o
3
y
m
Plug in the power cords of the devices to the AC outlet.
After making the connection as described above, make
sure to select the appropriate video input type by
following the steps in "SETTINGS FOR THE VIDEO INPUT"
on page 20.
rear of your TV
rear of this unit \
1 l“TTJ
j
Note to CATV system installer
• This reminder is provided to call the cable TV system installer's attention to Article 820-40 of the National Electrical
Code, which provides guidelines for proper grounding - in particular, specifying that the cable ground shall be
connected to the grounding system of the building, as close to the point of cable entry as possible.
EN 19