Limiter atck limiter rise, Output pan output levi side eq thru, Side eq freq – KORG Soundlink DRS REcording Console 168RC User Manual

Page 67: Sideeqq, Side eq gain trig mon, 150 ,cnt,r1...r50, Off, on, 100hz khz, I2.0...+12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Chapter 4. Effects

Limiter ATCK

limiter RISE

1...100

1.J00

Specify the attack time and release time of the compres-

sion.

Output PAN

Output LEVI

Side EQ THRU

Side EQ FREQ

SideEQQ

Side EQ GAIN

Trig Mon.

Higher settings will cause compression to be applied more
slowly.

Limiter - Attack / Release

Dry

150...11,CNT,R1...R50

0...100

OFF, ON

100Hz...10.0kHz

...

8.0

-I2.0...+12,

OFF, ON

Pan the effect sound and direct sound.

Set the output level.

Switch the equalizer on/off for the trigger signal. The
limiter uses this post-EQ signal to determine when to ap
ply compression. With the appropriate equalizer settings,
you can specify the frequency range to which the limiter

will respond.

Specify the center frequency of the trigger signal equal
izer.

Specify the width of the frequency range for the trigger
signal equalizer.

Set the gain of the trigger signal equalizer.

Switch between monitoring the effect output and moni
toring the trigger signal. When this is ON, the signal from
the limiter will not be output, and the trigger signal will

be output. This allows you to check the equalized trigger

signal. Normally you will leave this OFF.