Chapters. parameters, 1/2 /16 "off, on, G1/2...g7/8 "off, on – KORG Soundlink DRS REcording Console 168RC User Manual

Page 34: System, T pgn chi /system, Dig-ih-r, Iclk source, Solo mode ¡exclusive, Battery : ok, Clk source "int, dig-in-a, dig-in-b, wclk-in

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Mise

mode

Chapters. Parameters

This chapter explains the parameters of the 168RC for each mode.

MISC mode

Pairing

1/2 3/4

5/6

7/8

9/10 11/1213/M 15/16

rmi

GdS

Doaa Ddid [il!l

Daaa

Gl/2

G3/4

G5/6

G7/8

OFF

1/2... 15/16

"OFF, ON"

Here you can turn channel pairing on/off. When this is "ON," adjusting one of the channels will
cause the identical adjustment to be made for the paired odd/even channel. This function applies
to fader, mute, and EQ settings.

For channel fader operations, only the odd-numbered channel faders will be effective. If you oper
ate an even-numbered channel fader, both of the channel indicators will light, indicating that
operating this fader will have no effect. For incoming MIDI messages as well, fader, mute, and EQ
of even-numbered channels will be ignored.

Even when pairing is turned "OFF," the values that were set while pairing was in effect will re
main. This can be used as an easy way to copy odd-numbered channel settings to even-numbered
channels.

G1/2...G7/8

"OFF, ON"

These settings turn pairing on/off for the group buses. When "ON," the knob icons that indicate
the level of group buses in BUS MASTER mode will be joined by a line for adjacent buses. In this

case, operation will be valid only for odd-numbered knobs, and the even-numbered knobs will be
linked to the odd-numbered knobs.

System

t PGN Chi /System

DIG-IH-R

iCLK Source!__

Solo Mode ¡Exclusive

Battery : OK

ROM Uersionil.B

CLK Source

"INT, DIG-IN-A, DIG-IN-B, WCLK-IN"

Select the master clock that will determine the sampling frequency.

INT

; Use the internal clock of the 168RC.

DIG-IN-A : Use the clock that is input to the adat OPTICAL IN A. The device connected to the

adat OPTICAL IN A will be the clock master.

DIG-IN-B : Use the clock that is input to the adat OPTICAL IN B. The device connected to the

adat OPTICAL IN B will be the clock master.

WCLK-IN : Use the clock from the WORD CLOCK jack. Connect a 48 kHz TTL level clock to the

WCLK-IN.

For examples of actual connections, refer to the "System connection examples" at the end of this

manual.